All articles about the device and repair of the front and rear suspension of cars VAZ-2112 (Lada 112, hatchback) and their modifications.
Front suspension device Front suspension independent, with telescopic swivel struts, transverse levers, longitudinal extensions of the levers and a stabilizer bar. Front suspension: 1 - cross member; 2 -...
Front suspension — check of technical condition Checking the technical condition of the front suspension must be carried out in accordance with the periodic maintenance schedule (see " Periodic maintenance "). You can assess...
Rack ball joint — removal and installation To complete the work you will need: a puller for pressing out the fingers of the ball bearings; car stand. Removing 1. We prepare the car for work (see " Preparing the car for...
Front suspension strut — removal and installation To do the job, you will need a reliable stand under the car. Removing 1. We prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the front...
Front suspension strut — disassembly and assembly To complete the work you will need: spring ties; special tools for disassembling the suspension strut. Disassembly 1. Remove the rack from the car (see " Front suspension strut -...
Wishbone suspension — removal and installation To complete the work you will need: viewing hole or flyover; beard. Removing 1. We prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the...
Wishbone suspension — replacing rubber-metal joints Rubber-metal hinges are replaced when the hinge is turned in the lever, elasticity is lost, the rubber element of the hinge is chipped or squeezed out of the seat. To perform the...
Front suspension cross member — removal and installation Removing 1. Remove the engine mudguard (see " Mudguard of the engine - removal and installation "). 2. We unscrew the nuts securing the braces to the cross member and remove the...
Anti-roll bar — strut replacement To complete the work, you will need a viewing hole or overpass. Removing 1. We prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Two keys by 17...
Anti-roll bar — removal, disassembly and installation To complete the work, you will need a viewing hole or overpass. Removing 1. We prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Unscrew the nut...
Front wheel alignment — check To ensure the correct rolling of the wheels of the car, taking into account the operation of the suspension and steering, the elements of the front suspension must be installed in...
Rear suspension device The rear suspension of the car is made on "elastic" beam with coil springs and double-acting telescopic shock absorbers. The rear suspension beam consists of two trailing arms...
Rear suspension — check of technical condition Checking the technical condition must be carried out in accordance with the periodic maintenance schedule (see " Periodic maintenance "). You can assess the technical condition of...
Rear suspension beam — silent block replacement To replace the silent block, the removal of the beam from the vehicle is not required. We change the silent blocks in turn: first at one, then at the other beam lever. To complete...