Car engine management system VAZ-2110

All articles on the device and repair of components and assemblies of the engine control system of VAZ-2110 (Lada 110) cars and their modifications.

Engine management system — device and diagram
In VAZ 2110 cars, the engine management system turns the fuel pump on and off, controls the amount of air entering the engine cylinders, injects the required amount of fuel into...

Precautions when repairing the engine management system of a car
Attention. Do not touch the ECU terminals with your hands, as the engine management system is microprocessor-based and its electronic components may be damaged by electrostatic...

Engine Management System Relays and Fuses
On the vehicle, the engine control system circuits are protected by three fuses. The engine management system relays and fuses are located under the instrument panel console....

Electronic control unit (ECU) — removal, installation, replacement
Warning: Before performing repair work, read the precautions for repairing the engine management system (see " Precautions when repairing the engine management system "). Removal...

Ignition coils of engine 21124 (1.6i) — check and replacement
To perform repair work on checking ignition coils you will need: a multimeter (in ohmmeter and voltmeter mode). Checking and removing 1. We are preparing the vehicle for repair...

High-voltage spark plug wires for engine 2112 (1.5i) — removal, installation, replacement
Recommendation: It is more convenient to replace the high-voltage spark plug wires one by one. Location of high-voltage spark plug wires on the VAZ 2112 (l,5i)* engine: 1 - first...

Spark plugs — replacement
Note. The work on replacing spark plugs is shown on a VAZ 2110 with an injection engine 21124 (1.6i). The specifics of replacing spark plugs on a VAZ 2110 with an engine 2112...

Engine ignition module 2112 (1.5i) — checking, removal and installation
To perform repair work on checking the ignition module on a car with an injection engine 2112 (1.5i), you will need: a multimeter (in voltmeter mode). Examination 1. We are...

Injectors — checking and replacement
Note. The work on checking and replacing injectors is shown on VAZ 2110 cars with an injection engine 21124 (1.6i). The features of checking and replacing injectors of the 2112...

Idle speed control valve (ISC) — checking and replacement
Warning: Before performing repair work to check and replace the idle air control valve (IAC), read the precautions for repairing the engine management system (see " Precautions...

Evaporative Canister Purge Valve — Checking and Replacing
Warning: Before performing repair work to check and replace the purge valve of the adsorber on a VAZ 2110 vehicle, read the precautions for repairing the engine management system...

Crankshaft position sensor (CPS) car — removal, inspection, replacement
Warning: Before performing repair work to replace the crankshaft position sensor (CPS) on a VAZ 2110 vehicle, read the precautions for repairing the engine management system (see...

Camshaft position sensor (CPS) — removal, inspection, replacement
Note. The work on removing, checking and replacing the DPRV sensor is shown on a VAZ 2110 car with a VAZ 21124 (1.6i) injection engine. Removing and checking the camshaft sensor...

Throttle Position Sensor (TPS) — Checking and Replacing
Warning: Before performing repair work on a VAZ 2110 vehicle to replace the TPS sensor, read the precautions for repairing the engine management system (see " Precautions when...

Knock sensor (DS) — removal, inspection, replacement
Warning: Before performing repair work, read the precautions for repairing the engine management system (see " Precautions when repairing the engine management system "). To...

Mass Air Flow Sensor (MAF) — Checking and Replacing
Warning: Before performing repair work, read the precautions for repairing the engine management system (see " Precautions when repairing the engine management system "). To...

Oxygen Concentration Sensor — Checking and Replacing
Warning. The oxygen concentration sensor on the VAZ 2110 is installed next to the catalytic converter, which heats up to a high temperature when the engine is running. To avoid...

Coolant Temperature Sensor (CTS) — Removal and Check
Warning: Before performing repair work, read the precautions for repairing the engine management system (see " Precautions when repairing the engine management system "). To...

Speed sensor — checking and replacement
Warning: Before performing repair work, read the precautions for repairing the engine management system (see " Precautions when repairing the engine management system "). To...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Power unit: Control system VAZ-2115 (1997-2012)
➠ Power unit: Control system VAZ-21214 (1994-2006)
➠ Power unit: Control system VAZ-2107 (1982-2012)
➠ Power unit: Control system VAZ-2104 (1984-2012)

Share with friends: