Contents: Removal ↓ Installation ↓
To complete the work you will need:
- allen key by 8 mm with extension cord;
- soft pads for the jaws of the vice.
Removal
1. Remove the brake pads from the shield (see "Rear brake pads - removal and installation") and the brake cylinder (see above, "Rear brake slave cylinder - replacement").
2. Through the hole in the hub flange with a hex key by 8 mm we unscrew the four bolts that secure its axle.
3. Passing the parking brake cable through the hole in the support shield, remove the axle assembly with the hub and shield.
(The article is taken from the website: «www.VazBook.ru»)
4. Secure the shield in a vice with soft pads on the jaws. Using a large Phillips screwdriver and a ratchet, unscrew the two shield mounting screws.
5. Remove the shield from the hub axle.
Installation
1. Install the shield in reverse order.
2. Remove air from the hydraulic drive system (see "Hydraulic brake drive - bleeding").
3. Adjust the parking brake system (see "Parking brake - adjustment").