Removing
1. For convenience, remove the air filter (see "Air filter - removal and installation").
2. Loosen the tightening and turn off the clutch cable adjusting nut a few turns (see above, "Clutch release actuator - adjustment").
3. We remove the tip of the cable sheath from the slot of the bracket (The battery has been removed for clarity).
4. Disconnect the cable leash from the clutch release fork lever.
5. In the box, under the dashboard, with pliers (with narrow lips) remove the spring retaining clip of the cable end.
6. Remove the tip of the cable from the clutch pedal finger.
Warning! There is a plastic sleeve on the pedal pin, do not lose it.
7. In the engine compartment, remove the cable from the opening of the partition.
Installation
Install the cable in reverse order.
Adjusting the cable tension (see above, "Clutch release actuator - adjustment").