Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for repair work.
2. Move the side turn signal forward together with the sealing gasket.
3. Pulling back the rear part, remove the rubber protective cover of the turn signal from the opening in the front wing.
4. Remove the bulb holder together with the rubber protective cover from the turn signal housing.
5. Remove the faulty lamp from the socket.
Note. A faulty lamp must be replaced with a similar one with the same parameters. If the turn signal is colorless, then the A12-5-3 (WY5W) lamp with an orange bulb should be installed.
Installation
1. Install a new lamp on the car and assemble the turn signal in the reverse order.
2. Insert the turn signal into the hole in the front wing, pressing the rear part of the turn signal.
3. Press on the front part of the flashlight housing until the spring lock snaps into place.