crankshaft position sensor (DPKV) mounted on the cover of the oil pump opposite the drive disk on the alternator drive pulley.
You will need: key «on 10», screwdriver.
1. Disconnect the wire from the terminal «–» battery.
2. Wring out a clamp of fastening of a block of a plait of wires and disconnect a block from the gauge.
3. Turn out a bolt of fastening of the gauge …
4.... and remove the sensor from the hole in the tide of the oil pump cover.
5. Check the resistance of the crankshaft position sensor with an autotester. For a working sensor, it should be in the range of 550–750 ohms.
6. Install the sensor in the reverse order of removal.