1. Remove the distributor cap (see "Distributor Cap and Rotor - Check and Replace").
2. By turning the protective bracket around the axis, we open access to the opening of the roller bushing oiler.
3. Pour three to four drops of motor oil into the hole, lubricating the roller bearing.
4. Close the hole with a staple.
5. Lubricate the axis of the movable contact with one drop of motor oil. For clarity, the work is shown on a removed distributor.
6. Soak the lubricating wick (feltz) of the roller cam with two or three drops.
7. Install the distributor cap back into place.
Caution! Do not allow oil to come into contact with the distributor contact group to avoid failure of the ignition system.