Steering of cars VAZ-2121

All articles about the device and repair of components and elements of the steering of VAZ-2121 "Niva" cars and their modifications.

Steering device
The steering device is shown in Fig. 5-1 and 5-2. There are two possible options for installing the mouth of the bipod shaft: on a needle or ball bearing. The text provides...

Possible steering malfunctions, their causes and methods of elimination
Increased steering wheel free play Steering wheel is hard to turn Noise (knocking) in the steering Self-excited angular oscillation of the front wheels The car's deviation from...

General inspection of the steering system
If there are any problems with the steering system (knocking, increased free play of the steering wheel or, conversely, its tight rotation, etc.) inspect the steering components....

Checking the ball joints of the steering rods
First of all, check the movement of the rod end along the axis of the pins. To do this, using a lever and support, move the end parallel to the axis of the pin. The axial movement...

Checking and adjusting the clearance in the engagement of the roller with the steering gear worm
After making sure that there is no axial movement of the worm in the bearings, use puller A.47035 to push the ball joint pins out of the holes in the pitman arm and disconnect the...

Removal and installation the steering gear
Removal Disconnect the wires from the battery and remove the signal switch by unscrewing the screws that secure it. Remove the steering wheel. Remove both halves of the steering...

Disassembly and assembly of the steering gear housing
Disassembly Drain the oil from the steering gear housing. Fasten the housing to the bracket A.74076/R with the support A.74076/1. After unscrewing the nut securing the steering...

Checking and repairing the steering mechanism
Carefully inspect the working surfaces of the roller and worm for signs of wear, jamming or scratches. Replace worn or damaged parts. Check the clearance between the bushings and...

Disassembly and assembly of the steering shaft
Disassembly Loosen the universal joint fork clamp bolt and separate the intermediate and upper steering shafts. If the upper shaft or its bearings are damaged, flare the core...

Tie rods and ball joints — removal and installation
Remove the cotter pins and unscrew the nuts that secure the ball joints of the lateral rods to the levers on the steering knuckles. Using puller 67.7824.9516 (Fig. 5-10), remove...

Tie rods and ball joints — inspection and repair
Check the condition of the protective caps 2 (Fig. 5-11) as described above (see " Inspection, testing and adjustment of steering "). Replace damaged protective caps. Fig. 5-11....

Pendulum Arm Bracket — Removal and Disassembly
Separate the pendulum arm from the ball joints of the middle and right side rods by unscrewing the cotter pins and unscrewing the preliminary nuts and removing the ball joints...

Pendulum Arm Bracket — Check
Check the condition of the pendulum arm axle bushings; if you find ovality or an unacceptable gap between them and the axle, replace the bushings with new ones. Check the axle for...

Pendulum Arm Bracket — Assembly and Installation
Before assembly, lubricate the pendulum arm axle bushings and fill the space between them with LITOL-24 grease. The order of assembly of the pendulum arm bracket is the reverse of...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Steering VAZ-2110 (1995-2007)
➠ Chassis: Steering VAZ-2114 (2004-2013)
➠ Chassis: Steering VAZ-2109 (1984-1997)
➠ Chassis: Steering VAZ-21061 (1976-2006)
➠ Chassis: Steering VAZ-2107 (1982-2012)

Share with friends: