Front suspension of cars VAZ-2108

Features of the front suspension device
The front suspension is independent, with telescopic hydraulic shock absorber struts, with coil springs, lower wishbones with stretchers and an anti-roll bar. The suspension...

Possible faults of the front suspension
Possible faults of the front suspension, their causes and methods of elimination

Checking the condition of the suspension parts on the car
During each maintenance, as well as during repairs, check the condition of the protective covers of the suspension ball joints, paying particular attention to the absence of...

Checking and adjusting wheel alignment angles
These operations are performed on special stands according to the instructions attached to them. Checking the wheel alignment angles is mandatory if replacement or repair of...

Removal and installation the front suspension
To remove the suspension, place the vehicle on a lift or inspection pit and apply the parking brake. Remove the hub cap, loosen the front wheel mounting bolts and unscrew the hub...

Testing the telescopic strut and shock absorber on the stand
To determine the operability of the telescopic strut and shock absorber, their operating diagrams are checked on a dynamometer stand. The operating diagrams are taken according to...

Disassembly and assembly of a telescopic stand
Mark the relative positions on the head of the adjusting bolt 6 ( see figure 81 ) and on the rack bracket, so that during assembly the marks are aligned to approximately maintain...

Disassembly and assembly of the tie rod suspension arm and its bracket
Having noted the number of adjusting washers installed at the ends of the stretch 9 ( see figure 85 ), unscrew the nuts and disconnect the tensioners from the suspension arms 1...

Disassembling and assembling the upper support of the suspension strut
If the bearing of the upper support of the telescopic strut is worn, corroded or damaged, it is replaced. To do this, flare the support housing, and then press the bearing out of...

Disassembly and assembly of the stabilizer
Worn, damaged or destroyed rubber-metal hinges of the stabilizer struts are pressed out on a press using mandrels with an outer diameter of 34 and 37 mm and an inner diameter of...

Checking the technical condition of suspension units
Telescopic stand Wash all parts with gasoline or kerosene and dry them. Check that the parts meet the following requirements: the compression and rebound valve discs, as well as...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Front suspension VAZ-2101 (1970-1983)
➠ Chassis: Front suspension VAZ-2107 (1982-2012)
➠ Chassis: Front suspension VAZ-2114 (2004-2013)
➠ Chassis: Front suspension VAZ-21061 (1976-2006)
➠ Chassis: Front suspension VAZ-21214 (1994-2006)

Share with friends: