1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Holding the stretch with the key by 24 mm from turning, use a second key of the same size to unscrew the tensioner mounting nut.
3. Remove the thrust washer.
4. With a socket wrench by 17 mm we unscrew the three bolts that secure the bracket to the car body.
5. Remove the bracket from the stretcher.
6. If necessary, remove the second thrust washer and adjusting washers, remembering or writing down their number and location so as not to disturb the adjustment of the longitudinal tilt angle of the pivot axis.
Installation
Recommendation: After replacing the strut bracket, it is necessary to check the front wheel alignment angles at a service center.
Installation of all parts removed during disassembly is carried out in the reverse order.
Warning: When installing the adjusting washer, it is necessary that the chamfer on its inner edge faces the brace.
