The device and repair of the front suspension VAZ-1111 Oka

In this section, articles about the device and repair of the front suspension and wheels of the VAZ-1111 Oka car.

Features of the front suspension device
The front suspension is independent, telescopic, with hydraulic shock absorber struts, with coil springs, lower wishbones, with stretchers and anti-roll bar. The suspension design...

Possible faults of the front suspension
Possible faults of the front suspension, their causes and methods of elimination. Noise and knocking in the suspension when the car is moving Suspension struts are faulty -...

Determining the technical condition of suspension parts on a vehicle
During each maintenance, as well as during repairs, the condition of the protective covers of the ball joints is checked, paying particular attention to the absence of mechanical...

Checking and adjusting wheel alignment angles
These operations are performed on special stands according to the instructions attached to them. Checking the wheel alignment angles is mandatory if replacement or repair of...

Removal and installation the front suspension
To remove the suspension, place the vehicle on a lift or inspection pit and apply the parking brake. Loosen the front wheel mounting nuts, lift the front of the vehicle and remove...

Testing the telescopic strut and shock absorber on the stand
To determine the operability of the telescopic strut and shock absorber, their operating diagrams are checked on a dynamometer stand. The operating diagrams are taken according to...

Disassembly and assembly of a telescopic stand
Mark the relative positions on the head of the adjusting bolt 8 ( see figure 97 ) and on the rack bracket, so that during assembly the marks are aligned to approximately maintain...
There is 1 comment

Disassembly and assembly of suspension arms
If the rubber-metal hinges of the levers are worn, damaged or destroyed, they are pressed out. A special mandrel is used for pressing out and pressing in 1 (figure 107) ∅ 30 mm, a...

Checking the technical condition of the front suspension
Telescopic stand Wash all parts with kerosene or technical cleaning agents and dry them. Carefully check the compliance of the parts with the following requirements: the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Front suspension VAZ-2101 (1970-1983)
➠ Chassis: Front suspension VAZ-2107 (1982-2012)
➠ Chassis: Front suspension VAZ-2121 (1977-1994)
➠ Chassis: Front suspension VAZ-21061 (1976-2006)
➠ Chassis: Front suspension VAZ-2108 (1984-2003)

Share with friends: