Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Disconnect the wiring harness from the windshield washer fluid level sensor (see "Windshield washer reservoir low fluid level sensor - checking and replacing").
3. Disconnect the blocks of the two wires of the washer pump, having previously marked the block connected to the "+" terminal
(cm. "Windscreen Washer Electric Pumps - Removal and Installation"). 4. If there is a lot of antifreeze in the tank, then in order to save money, remove the windshield washer tank from the bracket without disconnecting the tube from the electric pump. Drain the liquid through the filler neck into a prepared container.
5. If necessary, use a Phillips screwdriver to unscrew the three screws securing the tank bracket and remove the bracket.
Installation
We install the tank in the reverse order.
(View the original on the internet resource: VAZBOOK)