Contents: Removal ↓ Installation ↓
The operation may be required for the convenience of repairing the engine and its systems, as well as when replacing the adsorber.
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the purge valve from the adsorber (see "Evaporative Canister Purge Valve - Checking and Replacing").
Tip: If necessary, the valve can be removed from the adsorber without disconnecting the hose and the wiring harness connector. To prevent sand from getting into the valve, it can be wrapped in a plastic bag and set aside.
The original source is published on the website: VAZBOOK
3. Using a Phillips screwdriver, loosen the clamp (1) and remove the hose from the adsorber pipe. Using a socket wrench, by 10 mm loosen the clamp (2) securing the adsorber.
4. Remove the adsorber.
5. If necessary, with a key by 10 mm we unscrew the two nuts securing the adsorber bracket and remove the bracket.
Installation
We install the adsorber in the reverse order.