Contents: Removal ↓ Installation ↓
Tip: Replacing a pump requires experience and precision (fuel module components may be damaged), therefore, in case of fuel pump failure, it is recommended to replace the fuel module assembly.
To perform the operation you will need: a hair dryer (technical) or hot water.
Removal
1. Remove the fuel module (see "Fuel module engine 11183 (1.6i) - removal and installation").
2. Remove the pump from the fuel module housing (see above, "Fuel module engine 11183 (1.6i) - cleaning the mesh filter").
Caution: The strainer is held in place by a retaining spring washer on the cylindrical boss of the fuel pump.
3. Remove the mesh filter from the electric fuel pump pipe.
Using a thin-bladed slotted screwdriver, carefully move the lock washer along the pump boss.
4. After pressing the lock, remove the fuel pump from the housing.
5. Hair dryer (or pouring boiling water over it) we heat up the end of the corrugated tube placed on the electric fuel pump nozzle.
Warning! Monitor the temperature of the heated parts, do not overheat the pump and tube.
6. Remove the corrugated tube from the pump branch pipe.
(The original is available on the online resource vazbook.ru)
Installation
We install the fuel module in the reverse order.
At the same time, while putting on the mesh filter, use a slotted screwdriver with a wide blade to press the spring washer of the filter onto the protrusion of the pump.
