Note. On the VAZ-2115, the rear license plate and its lamp are attached directly to the rear bumper trim, so before removing the rear bumper of this car, lift the carpet upholstery in the trunk, disconnect the wiring harness connector of the rear license plate lamp, unscrew the nut and remove the lamp's "minus" wire from the stud.
You will need: a 10 mm wrench, 10 mm and 13 mm socket heads, an extension, a ratchet, and a Phillips-head screwdriver.
1. Unscrew the two nuts securing the left side bracket of the bumper trim to the body.
2. Similarly, unscrew the nuts securing the right bumper trim bracket to the body.
3. Holding the nut, unscrew the bolt securing the left part of the trim to the bumper beam.
4. Similarly, unscrew the bolt securing the right part of the trim to the beam.
5. Unscrew the bolt securing the lower part of the bumper trim to the beam…
6. …and remove the trim.
Note: When removing the rear bumper trim on a VAZ-2115, do the following.
1. Remove the two screws and remove the license plate.
2. Unscrew the two nuts of the right and left lower fasteners of the bumper trim.
3. Holding the nuts, unscrew the two bolts securing the bumper trim to the beam and remove the trim.
7. Unscrew the two nuts securing the bumper beam to the brackets…
8. …and remove the rear bumper beam.
9. Unscrew the three nuts securing the left bracket of the rear bumper beam to the body…
10. …and remove the bracket.
11. Similarly, remove the right bracket securing the rear bumper beam to the body.
The text is on the website www.VazBook.ru
12. Install the removed rear bumper parts in the reverse order of removal.