1. Remove front fender moldings (see «Removal and installation of moldings»).
2. Remove the front sill trims (see «Removal and installation of facing overlays of thresholds»).
3. Remove the front fenders (see subsection «Removal and installation of forward fender liner»).
4. Disconnect the side fasteners facing the front buffer (see «Removal and installation of the forward buffer»).
5. Remove the side turn signal (see «Side turn signal replacement»).
6. Turn out the screw of fastening of facing of a headlight.
7. Remove the front turn signal (see «Replacing the front turn signal»).
8. Remove the screw of the front fastening of the right wing to the car body..
9.... screw securing the wing to the threshold of the body..
10.... and two screws securing the wing to the body pillar.
11. From the side of the engine compartment, unscrew the screw securing the wing to the radiator frame and the three screws securing to the mudguard of the body.
12. Carefully, so as not to deform, separate the right wing from the factory mastic and remove it.
13. If necessary, remove the left wing in the same way as the right one.
14. Install the wing in the reverse order of removal, and treat with an anti-corrosion compound the surfaces of the mudguard and body pillar in contact with the wing (see subsection «Body Care»).