Checking the gap between the rack stop and the nut: 1 – punch
Set the rack to the middle position, which is determined by the size (87±0.25) mm from the pinion axis to the rack end. Using a special device, load the rack with a force of P = (500±20) N [(51±2) kgf] (Fig. 7.4) at a distance of 84 mm from the pinion axis in the direction of the rack stop.
The maximum permissible gap between the stop and the nut is 0.2 mm. The maximum permissible movement X of the rack, measured through the relative movement of the pressing punch 1, should not exceed 0.16 mm (approximately until the collection of statistical data).
The information is posted on the portal VAZBOOK.RU