Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Disconnect the mass air flow sensor from the air filter housing (see "Mass Air Flow Sensor - Check and Replace").
3. Prying off the three rubber supports of the filter housing with a slotted screwdriver, remove them from the holes of the bracket.
4. Disconnect the air intake from the holder.
5. Remove the air filter housing with the air intake. If necessary, disconnect the air intake from the pipe of the air filter housing.
Installation
1. Prying with a screwdriver, we remove the rubber supports from the holes in the housing.
2. To facilitate the installation of the supports, we lubricate them with soapy water and install them in the holes of the bracket.
3. We install the air filter housing on the supports. Pressing on it, alternately pull out the supports with pliers until the body is fixed in their annular grooves.
4. Further installation of the removed parts is carried out in reverse order.