Attention! We carry out the work on an inspection pit or lift.
Using a 13 mm wrench, unscrew the tube fitting, holding the upper end of the hose with a 19 mm wrench.
Using pliers, remove the retaining clip of the hose tip..
…and we remove the upper end of the hose from the bracket hole.
Using a 17 mm wrench, unscrew the lower end of the hose from the plug of the working cylinder housing, holding it from turning with a 22 mm wrench.
We remove the flexible hose.
We install the flexible hose in the reverse order. We bleed the hydraulic drive (see Bleeding the clutch hydraulic drive).