We carry out work on a lift or a viewing ditch.
head «at 17» through the hole in the cross member, unscrew the nut of the lower mounting of the pillow.
key «at 17» unscrew the nut of the upper mounting of the pillow.
Raise the engine with a jack and remove the support cushion.
We install a new one in its place.
We bait the lower mounting nut of the pillow by hand through the cavity in the upper part of the cross member and tighten it with a wrench or a head «at 17».
If necessary, we disassemble the pillow, clamp it in a vice and with a key «on 10» unscrew the two nuts securing the cushion plate.
We remove the plate and take out the rest of the pillow parts.
Assemble the pillow in reverse order.