Contents: Removal ↓ Installation ↓
Removal
1. Remove the pressure and driven clutch discs (see "Clutch - replacement").
2. Using any available method, mark the position of the flywheel on the shaft.
3. With a socket wrench by 17 mm we unscrew the six flywheel mounting bolts, holding it from turning with a mounting blade or screwdriver, resting it against the protrusion of the cylinder block.
4. Remove the washer and flywheel.
5. If necessary, remove the upper cover of the clutch housing from the guide bushings.
Installation
We install the flywheel in the reverse order in accordance with the mark made during disassembly. Before tightening the flywheel mounting bolts, apply thread lock to their threaded part.
Note: The flywheel should be installed on the crankshaft in only one position. If the mark has worn off, the flywheel can be installed on the shaft using the factory mark - a hole is drilled on the outer side of the flywheel for this purpose. When installing the flywheel on the crankshaft, the mark should be located opposite the crankpin of the fourth cylinder. Do not confuse the mark with the balancing holes, which are made with a drill of a larger diameter
