Remove the spring clip and pull the hose end out of the bracket on the body.
2. Remove the rubber seal together with the hose from the bracket.
3. Unscrew the brake hose nipple from the wheel brake cylinder.
4. Plug the holes in the pipeline and the working cylinder.
5. Install the hose in the reverse order of removal. When installing the hose, do not forget to install a copper gasket on the nipple screwed into the cylinder. Replace a gasket that is too tightly compressed.
6. When installing the hose, make sure it is not twisted. A colored strip is applied to the hose for control.
7. Replace the rear brake hoses in the same way. After replacing the hoses, bleed the brake system.
