1. Disconnect the wire from the terminal «–» battery.
2. Remove the motor protection.
3. Remove the alternator drive belt (see «Replacing and adjusting the tension of the alternator drive belt»).
4. Disconnect the block with the wire from the output «D» generator.
5. Remove the protective rubber cover, unscrew the nut and disconnect the wires from the contact bolt (conclusion «B+»).
6. Turn out a tension bolt.
7. Turn away finally a nut of the top fastening of the generator.
8. Remove the tension bar.
9. Turn away finally a nut of the bottom fastening of the generator.
10. Remove the spacer.
11. Holding the generator, remove the bolt of its fastening and remove the generator down
12. Install the generator in the reverse order of removal.
13. Adjust the tension of the alternator drive belt (see «Replacing and adjusting the tension of the alternator drive belt»).