Contents: Removal ↓ Installation ↓
Removal
1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. Disconnect the wire from the negative terminal of the battery (see "Battery - Removal and Installation").
3. Remove the instrument panel (see "Instrument cluster model 2107 - removal and replacement of lamps").
4. Remove the radio panel (see "Radio panel model 2107 - removal and installation").
5. After opening the lid, use a Phillips screwdriver to unscrew the two screws securing the glove box body.
6. Remove the glove box housing from the instrument panel.
7. Unscrew the four screws securing the storage shelf.
8. Remove the shelf.
9. Pull and remove the handle from the headlight range control.
10. With a socket wrench by 21 mm we unscrew the hydraulic corrector mounting nut and push it inside the instrument panel.
11. Disconnect the wiring block A from the glove compartment light and disconnect the ground wire B.
12. Using a Phillips screwdriver, unscrew the two screws securing the heater control unit to the instrument panel.
13. Remove the central air duct from the engine compartment bulkhead.
14. Using a Phillips screwdriver, unscrew the four screws that secure the lower mounting of the instrument panel to the body (the photo shows the right mounting screw).
15. Using a short Phillips screwdriver, unscrew the three screws securing the instrument panel insert (the photo shows the screw for the right-hand fastening of the insert).
16. With a socket wrench by 10 mm unscrew the nut of the upper instrument panel mount on the left side.
17. Using the same tool, unscrew the nut of the upper instrument panel mount on the right side.
18. Unscrew the two nuts of the upper instrument panel mount, located in its middle part.
19. Remove the instrument panel.
Installation
The installation of the instrument panel is carried out in the reverse order.
The original is available on the website www.VazBook.ru