To perform the work, you will need an assistant, as well as a special key by 10 mm for brake pipes, a transparent vinyl tube of suitable diameter, a container for draining brake fluid, fresh brake fluid (see "Applications").
Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Remove the front wheel (see "Wheel - replacement").
3. Use pliers to remove the bracket that secures the brake hose.
4. Special key by 10 mm unscrew the fitting of the brake pipe, holding the tip of the hose with a wrench by 17 mm.
5. To reduce the loss of brake fluid, put a protective cap on the end of the tube (from the brake cylinder bleeder) and remove the hose tip from the bracket on the body.
6. Deep socket socket wrench by 10 mm unscrew the fixing bolt of the brake hose clamp.
7. Remove the fixing bracket.
8. socket wrench by 14 mm with an extension, unscrew the bolt-fitting of the brake hose tip.
9. Remove the hose with a bolt and copper sealing washers.
Installation
1. Replace the copper sealing washers with new ones.
2. Installation of a new hose is carried out in reverse order.
3. Similarly, we replace the hose on the opposite side.
4. We pump the front hydraulic brake circuit (see "Hydraulic brake drive - bleeding, replacement of brake fluid").