Steering Repair VAZ-21213

All articles about the device and repair of units and elements of the steering of VAZ-21213 Niva cars.

Steering device
The steering device is shown in Fig. 5-1, 5-2. Fig. 5-1. Steering: 1 - side pull; 2 - bipod; 3 - medium thrust; 4 - pendulum lever; 5 - Adjusting Coupling; 6 - lower suspension...

Possible steering malfunctions, their causes and methods of elimination
Increased steering wheel free play Cause of malfunction Method of elimination 1. The steering gear housing mounting bolts have become loose. 1. Tighten the nuts. 2. The steering...

General inspection of the steering system
If there are any problems with the steering system (knocking, increased free play of the steering wheel or, conversely, its tight rotation, etc.) inspect the steering components....

Checking the ball joints of the steering rods
First of all, check the movement of the rod ends along the axis of the pins. To do this, using a lever and support, move the end parallel to the axis of the pin. The axial...

Checking and adjusting the clearance in the steering worm bearings
Set the front wheels to the straight-ahead position and, turning the steering wheel in both directions, check whether the distance between the end of the crankcase 8 ( fig. 5-2 )...

Checking and adjusting the clearance in the engagement of the roller with the steering gear worm
After making sure that there is no axial movement of the worm in the bearings, use puller A.47035 to press out the ball joint pins from the holes in the pitman arm and disconnect...

Removal and installation the steering gear
Removal Disconnect the wires from the battery and remove the signal cover trim. Unscrew the steering wheel mounting nut, remove the steering wheel, and then both halves of the...

Disassembly and assembly of the steering mechanism
Disassembly Drain the oil from the steering gear and secure it to the bracket A.74076/R with the support A.74076/1. After unscrewing the pitman arm mounting nut 2 (Fig. 5-5) and...

Checking and repairing the steering mechanism
Carefully inspect the working surfaces of the roller and worm for signs of wear, jamming or scratches. Replace worn or damaged parts. Check the clearance between the bushings and...

Disassembly and assembly of the steering shaft
Disassembly Loosen the universal joint yoke clamp bolt and separate the intermediate and upper steering shafts. If the upper shaft or its bearings are damaged, flare the punching...

Steering linkage rods and ball joints
Removal and installation Remove the cotter pins and unscrew the nuts that secure the ball joints of the lateral rods to the levers on the steering knuckles. Using puller...

Pendulum arm bracket
Removal and disassembly Separate the pendulum arm from the ball joints of the middle and side rods by first removing the cotter pins and unscrewing the nuts and removing the ball...

Steering with driver's airbag in the steering wheel «SRS-40» by «Breed»
Features of the device The SRS-40 system is installed in the steering wheel, in addition to the seat belt, and is designed to provide additional protection for the driver's head...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Steering VAZ-2110 (1995-2007)
➠ Chassis: Steering VAZ-2114 (2004-2013)
➠ Chassis: Steering VAZ-21011 (1974-1983)
➠ Chassis: Steering VAZ-21061 (1976-2006)
➠ Chassis: Steering VAZ-2107 (1982-2012)

Share with friends: