Lighting and light signaling — general information 1 – block of wires of the index of turn 2 - hydraulic corrector 3 – block of wires of a headlight 1 - the hydraulic corrector is removed with the latch installed in this position...
Headlight and turn signal replacement 1. Disconnect the block with wires from the direction indicator. 2. Disconnect the wiring harness from the headlight. 3. Press the lock and turn the hydraulic corrector...
Side turn signal repeater 1. Through the wheel arch (see note) remove the bulb holder from the repeater housing. The repeater is removed from the rear of the front wheel niche. Turn the wheels for easy...
Rear light replacement 1 - body; 2 - lamp holder; 3 - latch; 4 - diffuser The diffuser is glued to the body of the flashlight, so it must be replaced as an assembly with the body. 1 – a lamp of light of...
Replacing the license plate light Note. The license plate light is installed in the lower end of the tailgate. 1. Pry with a screwdriver and slide the light to the right to disengage the hook on the housing. 2....
Interior lighting dome 1. Remove the diffuser by depressing the edge of the lamp housing on the left side. 2. Take out the lamp. 3. Loosen the four screws securing the lamp housing. 4. Remove the cover...
Plafond of directional light 1. Carefully pry off the cover housing with a screwdriver. 2. Remove the three plastic latches from the upholstery of the ceiling and remove the cover. 3. Disconnect the two...
Sound signal Before the beginning: disconnect the wire from the terminal "–" battery. Note. Cars can be equipped with sound signals of types C-304 or C-305 (collapsible) or types 20.3721-01 or...