Car headlight device The car is equipped with two block headlights, which consist of rectangular headlights with head and side light lamps and direction indicators. The headlight and direction...
Exterior car lighting Outdoor lighting is switched on by switch 10 (pic. 123) outdoor lighting at any position of the key in the ignition switch 6, except for the position «ABOUT» («Turned off»). At...
Lighting Maintenance At each maintenance, it is necessary to check the correct operation of the headlight hydraulic corrector, lighting devices and light signaling. Every 45,000 km, and also after the...
Car beep On cars, a sound signal of the C-309 type is used. It is located in the engine compartment and is mounted on a bracket welded to the radiator frame panel. The scheme for switching...
Windshield wiper and washer The windshield cleaner type 33.5205 with parallel brush movement is installed on cars. It consists of an electric motor with a gearbox (gearmotor), linkage and brushes. Windshield...
Headlight and rear window cleaners On some vehicles, headlight and rear window cleaners can be installed along with solenoid valves for washer fluid supply to the headlights and rear window. The circuit for...
Electric motor of the heater fan DC motor type 45.3730 with permanent magnet excitation. It is located horizontally on top of the heater housing. A rotary fan impeller is fixed on the motor shaft. The electric...
Electric motor of the fan of the engine cooling system To drive the fan of the engine cooling system, electric motors of domestic production of the ME-272 type or the production of the SFRY are installed. These are DC motors with...
Device of control devices All control devices of the car, together with control lamps, are combined into one unit - a combination of instruments ( see fig. 5 ), installed in the instrument panel socket....
Maintenance of control devices At each maintenance of the car, check the operation of control lamps and instruments. If there is a suspicion of inaccuracy in the readings of the instruments, then check them at...
The main malfunctions of control devices The arrow of the temperature indicator is constantly at the beginning of the scale Causes of the malfunction and how to fix it: instrument sensor defective. Preheat the engine,...
Carburetor Solenoid Valve Control System The system is used to control the on and off of the carburetor solenoid valve in the forced idle mode. This mode occurs, for example, when braking or shifting gears, when the...
Maintenance of the solenoid valve control system At each maintenance, the operation of the carburetor solenoid valve control system must be checked (forced idle economizer). Before checking, make sure that the wires are...
Embedded diagnostic system On cars VAZ-2108, VAZ-2109 and their modifications there is a built-in diagnostics system designed to monitor the technical condition of the car using a motor tester. This system...