Car engine electrical equipment VAZ-21099

Generator — General Information
1 – drive belt; 2 – adjustment bar; 3 – generator; 4 – generator mounting nut; 5 – protective cap of terminal "30" of the generator; 6 – block with wires; 7 – adjusting nut...

Removal the generator
1 – fan impeller; 2 – generator; 3 – capacitor; 4 – voltage regulator assembly with brush holder; 5 – generator marking; 6 – bracket Before you begin: disconnect the wire from the...

Disassembling the generator
1. Loosen the nut and remove the adjusting bar. 2. Unscrew the fastening nut and remove the pressure sleeve. 3. Remove the bolt and remove the bracket from the generator. 4....

Generator defect detection
1 – brush holder; 2 – brushes; 3 – voltage regulator Attention! When checking with 220 V, be careful - do not touch the live parts of the generator with your hands. 1. Check the...

Generator assembly
Assemble the generator in reverse order. Make sure that the holes in the covers for mounting the generator are aligned (according to the manufacturer, the alignment should not...

Starter — General Information
The starter is mounted on the clutch housing on the left side of the engine. Starter: 1 – cover from the collector side; 2 – body; 3 – drive side cover; 4 – drive; 5 – anchor...

Removal and installation the starter
Before you begin: disconnect the wire from the "–" terminal of the battery. 1. Disconnect the connector with the wire from the starter solenoid relay terminal. 2. Loosen the...

Disassembling the starter
Four excitation windings are fixed in the starter housing. Attention! Disassemble the traction relay only if it needs to be repaired. 1. Remove the nut from the lower contact...

Starter troubleshooting and repair
Attention! When checking with 220 V, be careful - do not touch the parts of the starter that are under voltage with your hands. 1. Clean all starter parts. 2. Check the condition...

Assembling the starter
1. Assemble the starter in reverse order, taking into account the following. 2. Securely solder the winding leads to the traction relay terminals. 3. Lubricate the splines and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Engine electrics VAZ-21051 (1979-2010)
➠ Power unit: Engine repair VAZ-2107 (1982-2012)
➠ Power unit: Engine repair VAZ-2101 (1970-1983)
➠ Electrical equipment: Engine electrics VAZ-2112 (1999-2007)
➠ Power unit: Engine repair VAZ-2106 (1976-2006)

Share with friends: