Front doors — design description Hung on two loops and bolted to the front pillars (pic. 159). Due to the enlarged holes in the hinges, it is possible to adjust the gap between the door and the body by a small...
Tailgate — design description Hung to the rear roof beam on two hinges 3 (pic. 162). Gaskets 2 and 4 are installed under the hinge links. A lock is attached to the bottom of the inner panel of the door. The...
Replacing the windshield, glass sidewalls and tailgate To remove the damaged windshield, remove the wiper arms, tuck the edges of the seal at the top of the flange of the body opening and, by pressing on the upper corners of the...
Removal and installation of a forward door Open the door all the way, unscrew the screws securing the eye of the door opening limiter to the front pillar and the bolts of the hinges (the assistant must support the door)....
Disassembly and assembly of the front door Removing the front door trim (see sect. « Removal and installation of an upholstery of forward doors »), the handle for adjusting the external rear-view mirror, the inner lining...
Front door lock adjustment Before adjustment outline the contours of the latch 21 ( see fig. 161 ) lock on the body pillar. If the door closes too tightly, loosen the fixing screws of the latch, move it...
Removal and installation of a door of a back Remove the brush and disconnect the electrical wires, open the door to failure, turn out the fingers of the stops 6 ( see fig. 162 ) from the threaded holes 5 and remove the stops...