Car gearbox repair VAZ-2108
Features of the gearbox design
Depending on the vehicle configuration, a four- or five-speed gearbox may be installed, combined with a differential and final drive, the gear ratio of which may have two values....
Depending on the vehicle configuration, a four- or five-speed gearbox may be installed, combined with a differential and final drive, the gear ratio of which may have two values....
Removal the gearbox
Place the car on a lift or inspection pit. Raise the engine hood and secure it in this position. From inside the engine compartment, perform the following operations: disconnect...
Place the car on a lift or inspection pit. Raise the engine hood and secure it in this position. From inside the engine compartment, perform the following operations: disconnect...
Disassembling the gearbox
Wash the gearbox, preventing water from getting into the crankcase, and install it on a stand for disassembly. Remove the rear powertrain suspension bracket and the clutch release...
Wash the gearbox, preventing water from getting into the crankcase, and install it on a stand for disassembly. Remove the rear powertrain suspension bracket and the clutch release...
Checking the technical condition of parts
Cleaning Before inspection, gearbox parts are cleaned. Using a brush or scraper, remove all deposits and clean the holes and splines from possible contamination, then wash and...
Cleaning Before inspection, gearbox parts are cleaned. Using a brush or scraper, remove all deposits and clean the holes and splines from possible contamination, then wash and...
Gearbox assembly
The gearbox assembly is carried out in the reverse order of disassembly. The following should be taken into account: before attaching the traction joint and gear selection lever...
The gearbox assembly is carried out in the reverse order of disassembly. The following should be taken into account: before attaching the traction joint and gear selection lever...
Selecting the differential bearing adjusting ring
The differential bearings should be mounted with a preload of 0.25 mm (for control - 0.15-0.35 mm). The preload is ensured by selecting the thickness of the adjusting ring 9 ( see...
The differential bearings should be mounted with a preload of 0.25 mm (for control - 0.15-0.35 mm). The preload is ensured by selecting the thickness of the adjusting ring 9 ( see...
Gearbox installation
The gearbox is installed in the reverse order of removal, tightening the bolts and nuts to the torques specified in adj. 1 . Before connecting the wheel drives to the axle gears,...
The gearbox is installed in the reverse order of removal, tightening the bolts and nuts to the torques specified in adj. 1 . Before connecting the wheel drives to the axle gears,...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More articles from other manuals on VAZ cars:
➠ Transmission: Car gearbox VAZ-2110 (1995-2007)
➠ Transmission: Car gearbox VAZ-21214 (1994-2006)
➠ Transmission: Car gearbox VAZ-21011 (1974-1983)
➠ Transmission: Car gearbox VAZ-2115 (1997-2012)
➠ Transmission: Car gearbox VAZ-2105 (1979-2010)
➠ Transmission: Car gearbox VAZ-2110 (1995-2007)
➠ Transmission: Car gearbox VAZ-21214 (1994-2006)
➠ Transmission: Car gearbox VAZ-21011 (1974-1983)
➠ Transmission: Car gearbox VAZ-2115 (1997-2012)
➠ Transmission: Car gearbox VAZ-2105 (1979-2010)
Share with friends:
- General information
- Specifications
- User manual
- Maintenance
- Car care
- Troubleshooting
- Power unit
- Engine repair
- Cooling and lubrication system
- Power and exhaust system
- Transmission
- Car gearbox
- Clutch and drive shafts
- Chassis
- Car suspension
- Steering
- Brake system
- Body
- Exterior
- Interior
- Doors and locks
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Engine electrics
- Ignition system
- General information
- Introduction to guide
- Power unit
- Engine repair
- Cooling and lubrication system
- Power and exhaust system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Exterior
- Interior
- Doors and glass
- Electrical equipment
- Equipment and devices
- Engine electrics
- Ignition system

