Electric equipment and devices of cars VAZ-21099

Relay and fuse box
The relay and fuse box is installed in the engine compartment, in the compartment in front of the windshield on the left side. Note: The earlier model relay and fuse box is...

Heater — design description
Heater (right view): 1. Fan. 2. Heater radiator. 3. Windshield defroster rod. 4. Heater control panel. Heater (left view): 1. Heater control flap rod. 2. Foot warmer flap rod. 3....

Removal the heater
Before you begin: drain the coolant and remove the instrument panel. 1. Loosen the clamps and disconnect both hoses from the heater tap pipes from inside the passenger compartment...

Removal and installation the heater fan
1. Under the instrument panel, disconnect the connector with the heater fan motor wires from the wiring harness. 2. Disconnect the electric motor ground wire by unscrewing the...

Disassembly and assembly of the heater fan
1 – Electric motor protective cover; 2 – right fan shroud; 3 – left fan casing; 4 – fan support Electric motor type 45.3730 Current consumption at maximum rotation speed, A, no...

Heater radiator
1. Remove the three radiator mounting screws. 2. Remove the radiator from the heater housing. 3. If the radiator is very dirty, clean it with a hair brush. Replace a leaky...

Heater rods
1. To replace the rods, first remove the holder, then disconnect the rod from the lever on the heater control panel. Fastening the rod to the heater control panel lever. 2. To...

Heater resistor
The resistor is used to select the fan operating mode. It has two spirals with a resistance of 0.23 and 0.82 Ohm. When turning the knob on the heater control panel, you can...

Windscreen Wiper — Removal
Before you begin: disconnect the wire from the "–" terminal of the battery. 1. Turn both brush levers to a vertical position and unscrew the nuts securing them. 2. Remove the...

Disassembling the windshield wiper
1 – electric motor; 2 – gearbox 1. Loosen the windshield wiper mechanism crank mounting nut. 2. Remove the crank from the gearbox shaft by prying it off with a screwdriver. 3....

Windscreen wiper defect detection
1. If the brush springs are damaged or have lost elasticity, replace them. 2. Check the ease of movement of the brushes in the brush holder. They should move freely, without...

Windscreen wiper assembly and installation
Assemble and install the wiper in reverse order, taking into account the following. 1. Make sure that when installing the anchor into the housing, the thrust ball is installed in...

Instrument panel (high)
Disconnect the wire from the "-" terminal of the battery. Set the wheels to the straight-ahead position. Disconnect the rod from the carburetor choke drive lever and the...

Instrument panel (low)
Disconnect the wire from the "-" terminal of the storage battery. Set the wheels to the straight-ahead position. Disconnect the rod from the carburetor air damper drive lever and...

Electrical diagram of the VAZ-21099 car
1 - headlight 31 - windshield wiper motor 2 - headlight washer motor (is installed on parts of manufactured vehicles) 32 - cigarette lighter 3 - underhood light switch 33 – heater...

Electrical diagram of the car VAZ-21099 Lux
1 - headlight 40 - windshield wiper motor 2 - headlight washer motors 41 - glove compartment light 3 - fog lights 42 – heater fan electric motor 4 - underhood light switch 43 -...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Equipment and devices VAZ-2110 (1995-2007)
➠ Electrical equipment: Equipment and devices VAZ-2107 (1982-2012)
➠ Electrical equipment: Equipment and devices VAZ-1111 (1988-1996)
➠ Electrical equipment: Equipment and devices VAZ-21051 (1979-2010)
➠ Electrical equipment: Equipment and devices VAZ-2114 (2004-2013)

Share with friends: