Clutch drive adjustment For ease of perception, the adjustment of the clutch actuator is shown on the gearbox removed from the vehicle. The total travel of the clutch pedal should be 125-135 mm. The...
Clutch replacement Disassembled clutch: 1 - pressure plate; 2 - clutch cover; 3 - diaphragm spring; 4 - driven disk Remove the gearbox ( see subsection 12.2. ). Note 1. When loosening the clutch...
Replacing the fork and clutch release bearing 1. Remove the gearbox ( see subsection 12.2. ). 2. Carefully pry off the protective cover with a screwdriver, remove it from the hole in the crankcase and remove it from the...
Clutch cable replacement For ease of reference, the disconnection of the drive cable from the clutch lever is shown on the box removed from the vehicle. 1 - clutch cable; 2 - rubber cushion; 3 - cable...
Replacing clutch and brake pedal bushings Clutch and brake pedals in collapsible form: 1 - the axis of the pedals; 2 - axle bushings; 3 - release spring of the clutch pedal; 4 - retraction spring of the brake pedal; 5 -...
Front wheel drive — design description Front wheel drive: 1 - shaft; 2 - external constant velocity joint (SHRUS); 3 - internal constant velocity joint (SHRUS) Attention! With the front wheel drive removed, in no case...
Removing the front wheel drive 1. Brake the vehicle with the parking brake and place chocks under the rear wheels. 2. Pry with a screwdriver and remove the protective cap of the hub nut. 3. Unscrew the hub nut,...
Replacement of CV joints of drive shafts Note. If during operation, when turning the car, knocks are heard in the wheel drive, check the CV joints. Rock the drive shaft by hand. If there is a backlash or the mudguards...
Front wheel drive installation 1. Install the front wheel drive in reverse order, taking into account the following: 2. Install a new inner pivot housing snap ring. Always replace the inner pivot housing...