Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the left front fender liner (see "Front fender liner - removal and installation").
3. Unscrew the two nuts securing the left bumper to the body and lower the edge of the bumper down (see "Front bumper - removal and installation").
[The article is taken from the website vazbook.ru]
4. Remove the front part of the decorative threshold trim (see above, "Threshold trim - removal and installation").
5. Remove the headlight trim (see "Headlight - removal and installation").
6. Remove the left headlight turn signal (see "Front direction indicator - removal and installation").
7. Remove the side turn signal (see "Side direction indicator - removal, bulb replacement and installation").
8. Key by 10 mm we unscrew the screw that secures the wing to the body bracket.
9. Unscrew the screw securing the wing under the car threshold.
10. From the inside of the wing, unscrew the two screws that secure the wing to the pillar...
...and also four self-tapping screws for the upper wing mount.
11. Carefully use a knife to trim the layer of sealant under the upper shelf of the wing.
12. Remove the wing.
Installation
We install the wing in the reverse order. Before tightening the screws, we achieve an even gap between the wing, the front door and the hood.