Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair"). WITH engine 11183 (1.6i) remove the decorative trim (see "Decorative engine trim 11183 (1.6i) - removal and installation").
2. Remove the protective cover from the sensor and disconnect the wire tip from the sensor output.
3. With a spanner by 21 mm we unscrew the sensor and remove it.
(The original is available on the website: VAZbook)
Note: The sensor can only be checked on a special stand or by replacing it with a known good one.
Installation
We install the sensor in the reverse order.
Start the engine and make sure there are no oil leaks from under the sensor. If necessary, replace the aluminum sensor sealing ring.