Contents: Removal ↓ Installation ↓
Note: When the ignition is turned on, all indicator lamps of the on-board monitoring system indicator unit should light up for 5-7 s. If this does not happen, the indicator unit or its power supply circuit is faulty (see "Fuse and relay mounting block", fuse F10).
Removal
1. Remove the instrument panel trim without disconnecting the wiring harness connectors from it (see "Instrument panel - removal and installation").
2. Disconnect the wiring harness connector from the indicator unit.
3. Using a Phillips screwdriver, unscrew the two screws securing the unit to the overlay.
4. Remove the indicator unit.
Installation
We install the on-board control system indicator unit in the reverse order.
(The article is taken from the website: VAZbook)