When the crankcase ventilation system is clogged, the pressure in the crankcase increases, which can cause oil to leak through the seals and gaskets.
You will need: keys «at 13», «at 17», screwdriver.
1. Remove the head cover (see «Valve clearance adjustment»).
2. Turn out long 1 and short 2 bolts of fastening of an oil separator from the inside of a cover of a head of the block, remove washers.
3. Remove the oil separator housing.
4. Remove the mesh pack from the head cover.
5. Thoroughly wash the screens, oil separator housing and block head cover with kerosene.
6. Turn the nets in the bag so that they are equally oriented, and install the bag into the lid so that on one side it rests on the protrusions in the lid, and on the other hand..
7.... the hole for the bolt of the oil separator housing was visible. Establish the case of an oil separator and screw in bolts of its fastening.
8. Check the condition of the cover gasket, replace if necessary.
Install the cover on the block head.