Contents: Removal ↓ Installation ↓
Removal
1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. Install the glass in the lower position.
3. Remove the rear door trim in the same way as the front door (see "Front door trim - removal and installation").
4. Remove the protective film from the door.
5. Using a Phillips screwdriver, unscrew the screw securing the rear upper guide of the drop-down window.
6. Remove the seal from the upper part of the door frame.
7. With a socket or open-end wrench by 10 mm we unscrew bolt A and nut B securing the rear guide.
8. Remove the upper part of the guide from the fixed glass seal.
The text is published on the portal: vazbook.ru
9. Tilt the upper part of the fixed glass forward and remove it.
10. Remove the seal from the stationary glass.
Caution: Before performing the following operation, it is recommended to mark the position of the cable relative to the pressure plate.
11. Using a Phillips screwdriver, unscrew the two screws securing the cable pressure plate to the glass bracket.
12. Remove the plate and lower the glass until it stops.
13. Remove the door trim and two chrome trims (see "Front door glass - removal and installation").
14. Lifting the drop glass with the bracket and tilting it inward, we remove it from the door.
Installation
The installation of the rear door glass is carried out in the reverse order, using the previously applied mark on the cable as a guide.