We put marks with a chisel at the junction of the cardan shaft with the flange of the drive gear of the final drive. key «at 13» unscrew the four self-locking nuts, holding the propeller shaft from turning with a large screwdriver.
Separate the joint of the flanges.
We mark the mutual position of the shaft and the centering flange of the elastic coupling.
With an awl, we bend four locking antennae on the seal holder near the elastic coupling..
... and move it along with the seal towards the cardan shaft.
head «at 13» unscrew the two nuts and remove the safety bracket.
Holding the driveline with the key «at 13» unscrew the two nuts and remove the cross member of the intermediate support from the studs of its fastening to the body.
The cross member of the elastic support is fixed to the body through rubber washers.
We put forward the cardan shaft from the spline connection with an elastic coupling and remove it.
We install the driveline in the reverse order of removal, lubricating the splines with Fiol-1, Fiol-2U or SHRUS-4 grease and aligning the marks made earlier.
After installing the splined part of the cardan shaft into the sleeve of the centering flange of the elastic coupling, we assemble the clip. With one screwdriver we move the sealing clip forward, and with the other we bend its locking antennae in turn.