Removal and installation of doors 1. Disconnect the door stop from the rack with pliers. 2. While holding the door in the open position, unscrew the screws 1 securing the door hinges to the body pillar with an...
Dismantling the front doors Front right door lock 1 – case of lock retainer; 2 - rotor; 3 - retainer cracker; 4 - cracker spring; 5 – lock switch; 6 - outer handle of the lock; 7 - lock lock button; 8 - lock...
Front door assembly Power window drive 1 - roller mounting bracket; 2 - pressure plate for clamping the cable; 3 – sliding glass clip; 4 - upper roller; 5 – the mechanism of a window regulator; 6 -...
Disassembly and assembly of rear doors The disassembly and assembly operations for the rear and front doors are the same except for the following: to remove the fixed glass, first remove the guide grooves of the...
Door adjustment The outer gaps between the doors and the body must be the same and uniform along the entire perimeter of the opening. 1. Impact screwdriver 2 (see subsection 12.5.1 ) loosen the...
Door lock adjustment Before adjusting the lock, it is recommended to outline the contour of the latch on the body pillar. 1. If the door closes too tightly, loosen the bolts securing the latch, move...
Power window adjustment 1. To adjust, remove the door upholstery and lower the glass down. Loosen the screws 3 of the cable pressure plate 4. Then lower the glass all the way into the rubber buffer 2,...
Removing and installing the trunk lid Removing the trunk lid 1 – cover lock; 2 – hinge fastening nut; 3 - loop; 4 - torsion bar The trunk lid is hung on the body on two front hinges 3 and is locked with a lock 1. In...
Windshield replacement 1. To take out the damaged glass, remove the wiper arms, the seal bezel and, by pressing on the upper corners of the glass, squeeze it out. In this case, the assistant must...
Rear window replacement 1. To remove the glass, remove the edging of the seal and, by pressing on the lower corners of the glass, squeeze it out. In this case, the assistant must support the glass from...
Removal and installation of the windshield washer pump Windshield washer pressure pump 1 - cover; 2 - clip of the switch; 3 - lower contact of the switch; 4 - block with contacts; 5 – the top contact of the switch; 6 - exhaust valve;...
Removal and installation of windshield washer jets Windshield washer jet 1 - atomizer; 2 - screw; 3 - bushing; 4 - jet body with fitting If the jets are clogged, remove and disassemble them. 1. On the side of the air intake box of...