2. Securely solder the winding leads to the traction relay terminals.
3. Lubricate the splines and journals of the armature shaft with engine oil...
4....rear cover and intermediate support bushings...
[The information is published on the website VAZbook.ru]
5....the tip of the traction relay anchor...
6....splines of the overrunning clutch.
7. Adjust the axial clearance of the starter armature shaft by selecting adjusting washers. The clearance should be no more than 0.5 mm.
8. Place the support on the lever with the protrusion towards the anchor.
9. The tie rods must pass through the insulating tubes.
10. When connecting the lever to the end of the traction relay armature, the tongue on the end of the armature must be directed downwards.