Contents: Removal ↓ Installation ↓
An assistant will be needed to complete the job.
Removal
1. With a socket wrench by 10 mm with a deep head, unscrew the two nuts of the lower bumper mount (one nut on each side of the car).
2. Using the same key, unscrew two bolts (one on each side), securing the bumper from above. The bolts are located next to the rear lights.
Warning! When performing the following operation, do not move the bumper too far from the body to avoid damaging the license plate light wiring.
3. Carefully, trying not to damage the paintwork of the body, simultaneously move the bumper back from both sides and remove it from the brackets.
4. Remove the rubber plug (3) from the rear body panel (1), pull out the wiring harness block (2). Disconnect the blocks.
Installation
We install the bumper in the reverse order.