2. Lift the rear seat cushion and fold back the edge of the carpet.
3. Using a Phillips screwdriver, unscrew the two screws securing the hatch cover and remove the cover.
4. Disconnect the wiring harness connector from the fuel module.
5. After turning on the starter, turn the crankshaft for 10-15 seconds.
Note: If we start the engine at the same time, we wait until all the gasoline in the fuel line is used up and the engine stalls.
6. Turn off the ignition.
Assembly
1. Connect the wiring harness connector to the fuel module.
2. Install the hatch cover in place and secure it with two screws.
3. Return the rear seat cushions to their original position.
Warning! After releasing the pressure, a small amount of gasoline remains in the fuel line.