Warning: Before performing any work, read the safety regulations for servicing and repairing the power supply system (see "Safety precautions for maintenance and repair of the power supply system").
Sequence of repair work
1. Preparing the vehicle for work (see point 2a "Preparing a car for maintenance and repair").
2. Raise the rear seat cushions.
3. Bend back the edge of the carpet.
4. Using a Phillips screwdriver, unscrew the two screws securing the hatch cover.
5. Remove the hatch cover.
6. Disconnect the wiring harness connector from the fuel pump fuel module.
7. After turning on the starter, turn the crankshaft for 10-15 seconds.
Note: If we start the engine, we wait until all the gasoline in the fuel line is used up and the engine stalls.
8. Turn off the ignition.
9. Connect the wiring harness connector to the fuel module.
[The material is posted on the online resource VAZBOOK]
10. Install the hatch cover in place and secure it with two screws.
11. Return the rear seat cushions to their original position.
Warning: After releasing the pressure, a small amount of gasoline remains in the fuel line.