- key "at 17" or replaceable head "at 17"
- knob
- screwdriver
The belt latch in the initial position is installed in the holder, which is also a decorative overlay for the upper belt attachment.
The belt buckles are bolted to the floor tunnel (under the plugs).
Attention! For fastening of seat belts and their locks use only special bolts.
1. Remove the belt latch from the holder.
2. Remove decorative trim (belt latch holder). If you cannot remove the trim by hand, carefully pry it off with a screwdriver.
3. Loosen the seat belt top mounting bolt, remove the spring and flat washers.
4. Remove the bolt cap from the lower seat belt anchor and...
5.... unscrew the bolt.
6. Remove the seat belt from the vehicle.
7. To replace the seat belt buckle, remove the bolt cap and...
8.... turn away a bolt of fastening of the lock. Install the seat belts and their locks in the reverse order of removal.