- keys "for 8", "at 13" (two) or interchangeable heads "for 8", "at 13"
- knob
- screwdriver
The front seats are mounted on skids, the guides of which are attached to brackets on the floor of the body.
Attention! Seat assemblies are not interchangeable. The operation is shown on the example of the left seat. The right one is replaced in the same way.
1. Slide the seat all the way back and unscrew the two front bolts securing the guide rail.
2. Slide the seat all the way forward and unscrew the nut of the rear fastening bolt of the right sled guide, holding the bolt head from turning with the second wrench.
3. Turn away a bolt of back fastening of the left directing sled.
4. Remove the front seat and take it out of the car through the side door.
5. Note that there are four flat washers on the body brackets where the seat rails are attached. When installing the seat, do not forget to put them in place.
6. Install the front seat in the reverse order of removal, and lubricate the slide guides with FIOL-1 grease.