Gearbox assembly and repair VAZ-1111 Oka

In this section, articles on the device and repair of gearbox components of the VAZ-1111 Oka car.

Features of the gearbox design
The vehicle is equipped with a two-shaft, four-speed gearbox with helical engagement. The gearbox is combined with the main gear and differential. Primary shaft 1 (figure 77) is...

Possible gearbox malfunctions
Possible gearbox malfunctions, their causes and methods of elimination. Noise in the gearbox Wear of gear teeth - Replace worn parts. Bearing wear - Replace worn bearings. Low oil...

Removal the gearbox
Place the vehicle on a lift or inspection pit. Raise the engine hood and secure it in this position. From inside the engine compartment, perform the following operations:...

Disassembling the gearbox
After removing the coupling with the clutch release bearing, wash the gearbox, preventing water from getting into the crankcase, and install it on a stand for disassembly. Remove...

Checking the technical condition of gearbox parts
Before inspection, the gearbox parts are cleaned. Using a brush or scraper, remove all deposits and clean the holes, internal ring grooves in the secondary shaft gear bushings and...

Gearbox assembly
The gearbox assembly is carried out in the reverse order of disassembly. The following should be taken into account: before attaching the traction joint and the lever to the gear...

Selecting the differential bearing adjusting ring
The differential bearings should be mounted with a preload of 0.25 mm (for control 0.15-0.35 mm). The preload is ensured by selecting the thickness of the adjusting ring 14 ( see...

Gearbox installation
The gearbox is installed in the reverse order of removal, tightening the bolts and nuts to the torques specified in adj. 1 . Before connecting the wheel drives to the axle gears,...

Features of the front wheel drive device
The drive of each wheel consists of two constant velocity joints and a shaft 9 (figure 92). The drives of the right and left wheels are not interchangeable, as they have different...

Removal and installation the wheel drive
Place the vehicle on a lift or inspection pit and perform the following operations on both sides of the vehicle: unscrew the front wheel mounting nuts and remove the wheel with...

Disassembly and assembly of the wheel drive
Disassembling the outer hinge The hinge is disassembled only if the cover 7 is damaged ( see figure 92 ), when there is a need to wash the hinge parts and replace the lubricant...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Transmission: Car gearbox VAZ-2110 (1995-2007)
➠ Transmission: Car gearbox VAZ-21214 (1994-2006)
➠ Transmission: Car gearbox VAZ-21011 (1974-1983)
➠ Transmission: Car gearbox VAZ-2115 (1997-2012)
➠ Transmission: Car gearbox VAZ-2105 (1979-2010)

Share with friends: