Car gearbox VAZ-11113 «Ока»

Removal and installation the gearbox
You will need: keys "10", "13", "17" and "19" gearbox support Disconnect the wire from the "–" terminal of the battery. Drain the oil from the gearbox. Remove the starter. Loosen...

Disassembly and assembly of the gearbox
You will need: keys "10", "13" and "22" screwdriver hammer snap ring pliers Remove the gearbox and drain the oil if this has not been done beforehand. To replace the clutch...

Secondary shaft repair
Secondary shaft of the gearbox in assembly: 1 – secondary shaft; 2 – synchronizer of 1st and 2nd gears; 3 – 3rd gear pinion; 4 – 4th gear pinion; 5 – rear shaft bearing; 6 –...

Synchronizer repair
Synchronizer details: 1 – hub; 2 – coupling; 3 – cracker; 4 – ball; 5 – spring If the gear engages unclearly or with great effort or does not engage at all, before disassembling...

Primary shaft repair
Primary shaft of the gearbox assembly: 1 – primary shaft nut; 2 – 4th gear pinion; 3 – 3rd gear pinion; 4 – reverse gear pinion; 5 – inner ring of the front bearing; 6 – primary...

Differential repair
Differential: 1 – speedometer drive pinion; 2 – satellite; 3 – axle gears; 4 – driven gear of the main transmission; 5 – satellite axis; 6 – differential housing; 7 – differential...

Selecting the differential bearing adjusting ring
You will need: key "13" 1.25mm thick mounting ring indicator with stand and support plate calipers Press the oil seal and outer race of the differential bearing out of the gearbox...

Gear selection mechanism repair
Gear selection mechanism: 1 – reverse gear engagement fork; 2 – gear selection lever; 3 – upper spring; 4 – mechanism body; 5 – lower spring You will need: key "10" screwdriver...

Replacing gearbox seals
Drain the transmission oil and disconnect the front wheel drives from the transmission (see subsection 11.3.1.) . The inner CV joint seals can be replaced without removing the...

Replacing the gear shift lever axle bushings
You will need two 10 mm wrenches. 1. Loosen the gear shift lever handle. 2. Untie the cord at the front of the cover. 3. Remove the cover from the lever. 4. Using a second key to...

Gear Shift Lever Repair
You will need: key "13" screwdriver hammer The gearshift lever should rotate freely in the ball joint without binding. If not, check and, if necessary, replace the ball joint and...

Adjusting the gear shift drive
You will need: key "13" screwdriver 1. Loosen the clamp securing the gear shift rod to the gear selector shaft joint. 2. Loosen the clamp with a screwdriver to allow the rod to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Transmission: Car gearbox VAZ-2110 (1995-2007)
➠ Transmission: Car gearbox VAZ-21051 (1979-2010)
➠ Transmission: Car gearbox VAZ-2107 (1982-2012)
➠ Transmission: Car gearbox VAZ-2114 (2004-2013)
➠ Transmission: Car gearbox VAZ-21099 (1990-2004)

Share with friends: