Front suspension of cars VAZ-11113 «Ока»

Removal and installation a telescopic stand
Telescopic stand: 1 – suspension spring; 2 – shock absorber strut; 3 – nuts for the lower mounting of the telescopic stand; 4 – upper support of the telescopic stand; 5 – nuts for...

Repair of telescopic stand
You will need: key "8", "19" spring compression tie Remove the telescopic stand from the vehicle. Recommendation: Repairing the shock absorber strut usually does not lead to the...

Replacing the ball joint
Installing the ball joint: 1 – ball joint; 2 – steering knuckle; 3 – protective cover; 4 – self-locking nut of the ball joint pin; 5 – front suspension arm You will need: keys...

Replacing the front suspension arm
You will need: keys "17" (two) and "19" (two) ball joint press puller Remove the appropriate wheel. If you notice knocks and noises in the front suspension, uneven wear of the...

Replacing the stretch
You will need keys "19" (two) and "22". Remove the appropriate wheel. If there are knocks and noises in the front suspension, uneven wear of the tire treads, check the strut and...

Replacement of anti-roll bar components
You will need: keys "13", "17" (two) screwdriver hammer The ends of the stabilizer bar must be in the same plane. If the bar is slightly deformed, it can be straightened;...

Replacing the front wheel hub bearing
You will need: keys "17", "19" (two), "30" screwdriver beard hammer fixture with a set of mandrels for pressing bearings snap ring pliers marker Attention! If, when swinging a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Front suspension VAZ-2101 (1970-1983)
➠ Chassis: Front suspension VAZ-2107 (1982-2012)
➠ Chassis: Front suspension VAZ-2114 (2004-2013)
➠ Chassis: Front suspension VAZ-21061 (1976-2006)
➠ Chassis: Front suspension VAZ-21214 (1994-2006)

Share with friends: