Car engine fuel system VAZ-11113 «Ока»

Removal and installation the air filter
You will need key "10" screwdriver 1. Loosen the clamp and disconnect the crankcase ventilation hose from the fitting on the air cleaner cover. Remove the clamp. 2. Remove the...

Checking the fuel pump
You will need: screwdriver rag Explanation: The manual fuel priming lever only functions when the camshaft is in a certain position. Therefore, if fuel does not flow through the...

Removal and installation the fuel pump
You will need: key "13" screwdriver Remove the air filter (see subsection 10.10.1.) . When installing the fuel pump, check and, if necessary, adjust its supply using gaskets. To...

Fuel pump repair
You will need: keys "8" and "10" screwdriver Remove the fuel pump (see subsection 10.10.3.) . Recommendation. Before disassembling the pump, check the tightness of its valves. To...

Replacing the traction and adjusting the throttle drive
You will need: keys "8", "13" (two) screwdriver Remove the air filter (see subsection 10.10.1.) . If the cable threads break or the cable moves with difficulty in the casing,...

Replacing the traction and adjusting the air damper drive
You will need: key "8" awl pliers Remove the air filter (see subsection 10.10.1.) . If the wire rod in the casing is difficult to move, you can try to lubricate it. To do this,...

Removal and installation the carburetor
You will need: keys "8" and "13" screwdrivers Disconnect the wire from the "–" terminal of the battery. Remove the air filter (see subsection 10.10.1.) . 1. Loosen the bolt...

Carburetor repair
You will need: keys "7", "8", "11" and "13" set of drills ∅ 1.1-1.5 mm copper wire ∅ 0.2-0.25 mm screwdrivers pliers with long thin jaws Remove the carburetor from the vehicle...

Adjusting the carburetor trigger
You will need: two drills (or round caliber) ∅ 0.8 and ∅ 2.2 mm key "7" screwdriver Remove the carburetor from the vehicle (see subsection 10.10.7.) . If starting a cold engine is...

Adjusting the fuel level in the carburetor float chamber
You will need: two screwdrivers (with flat and cross blades) key "8" caliper with depth gauge shank Remove the air filter (see subsection 10.10.1.) . The fuel level in the float...

Adjusting engine idle speed
You will need: screwdriver pliers Idle speed adjustment is performed with the air filter installed (the filter has been removed from the photos for clarity) when the engine is...

Replacing the fuel tank
You will need: keys "7", "10" and "13" screwdriver Disconnect the wire from the "-" terminal of the battery. Drain the fuel from the tank using a special hose with a bulb....

Replacing the fuel level indicator sensor
You will need: key or replaceable head "7" crank screwdriver Disconnect the wire from the "-" terminal of the battery. You can check the sensor's serviceability using an ohmmeter...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Power unit: Power and exhaust system VAZ-21099 (1990-2004)
➠ Power unit: Power and exhaust system VAZ-21061 (1976-2006)
➠ Power unit: Supply system VAZ-2110 (1995-2007)
➠ Power unit: Supply system VAZ-2105 (1979-2010)
➠ Power unit: Supply system VAZ-2115 (1997-2012)

Share with friends: